Its netsquad as single Service Provider with two different Last mile media with two different LM only.
As per Regional Feasibility Availed - Preferred Options of 2 different Tx LM.
CPE Protocol will be e-BGP.
Netsquad team will configure CPE with 2 eBGP peering sessions with netsquad IPV4 Pool & netsquad Pvt ASN to run / configure eBGP- Active Passive mode only.
Netsquad circuits with two e-BGP sessions ( on 2 set of /30 WAN subnets ) and LAN static IP pool to be configured at DLM CPE.
CPE configuration– to be configured with static LAN IPV4 pool which to be further sub divided into two subnets.
CPE shall advertise the supernet which contains all IP Addresses on both circuits.
CPE config : based on customer LAN network traffic , Default route shall be advertised on both link.
Only one prefix per subnet to be allowed and to be added in both the links. ( any prefix added must be there for both the links )
Customer to provide rack space and power to connect NETSQUAD Mux and ILL termination equipment’s under safe environment.
Anything not discussed are null and void and to be taken up as new requirement and subject to further validations only.